Siphon Air Atomizing Nozzle Introduction
syphon air atomizing nozzle introductionkh
The special internal structure design of siphon atomizer enables the liquid and gas to mix evenly.Can adjust the liquid flow, in the environment without changing the air pressure and liquid pressure, can also produce the desired spray.
The siphon type air atomizing nozzle is the air atomizing nozzle that uses the siphon principle to spray.Using stainless steel material, siphon type air atomizing nozzle structure can not pump and suction liquid, can spray a very fine spray effect.
Siphon type air atomizing nozzle is the air flow and liquid flow influence each other and produce mist device, this device special internal structure design can make the liquid and gas uniform mix, produce fine droplet size spray or coarse droplet spray.
Siphon type air atomizing nozzle is the device that the air flow and the liquid flow affect each other and produce the mist. The special internal structure design of this device can make the liquid and gas mix evenly, and produce the spray of fine droplet size or coarse droplet spray.In general, a finer droplet spray can be obtained by increasing the gas pressure or decreasing the liquid pressure, resulting in a higher gas flow rate and liquid flow rate ratio.
The working principle of the siphon type air atomizing nozzle is to use the force phenomenon of the liquid level height difference. After the liquid is filled with an inverted U-shaped tubular structure, the high end of the opening is placed in the container full of liquid. The liquid in the container will continue to pass through the siphon from the opening to the lower one.
Siphon nozzle working principle phenomenon
1. After filling an "inverted U-shaped" tube, place the higher end of the opening in a container full of liquid and the other end at a level lower than that of the higher container. The liquid will continue to flow out of the container through the U-shaped tube.
2. The essence of siphon is caused by gravity and inter molecular cohesion.In the device, the liquid at the highest point in the pipe moves to the lower orifice under the action of gravity, and negative pressure is generated inside the U-shaped pipe, resulting in the liquid at the high orifice being sucked into the highest point, thus making the liquid flow into the container at the low position continuously.
3. The siphon must be filled with water before use, otherwise both ends of the nozzle will be affected by atmospheric pressure, and water can not enter the pipe, of course, water can not flow.
According to the siphon principle MISTEC Spraying manufacturers provide siphon air atomizing nozzle is widely used in the industry, the working principle of siphon air atomizing nozzle can adjust the liquid flow, without changing the air pressure and liquid pressure in the environment, can also produce to meet the ideal spray, so it has a strong adaptability.Each spray unit consists of an air cap and a liquid feather, offering both fan and circular spray patterns and a wide flow range.The nozzle body inlet connectors are available in a variety of sizes for most commonly used piping.The above nozzle parts are interchangeable, which provides flexibility for obtaining different spray performance.
Adjustable air atomizing nozzle can adjust the liquid flow, without changing the air pressure and liquid pressure in the environment, can also produce the required spray, so it has a strong adaptability.Each spray unit consists of an air cap and a liquid feather, offering both fan and circular spray patterns and a wide flow range.The nozzle body inlet connectors are available in a variety of sizes for most commonly used piping.The above nozzle parts are interchangeable, which provides flexibility for obtaining different spray performance.
